How do Shanghai injection molding manufacturers deal with product bursting?

Author: MULAN - Plastic Molding Manufacturer

Burst of plastic products is a quality problem that often occurs in injection molding manufacturers. This nature is very serious. The main reason is how it is formed. When the black material is burst, customers generally suspect whether too much nozzle material is added. Because the water inlet material is a cause of bursting. The following editor from Shanghai Plastic Mold Factory Xingye will introduce how to deal with the problem of product bursting: There is another kind that bursts with a single touch. In place, make the weld line on the top of the bumped hole.

It is also the thinner part on the outside. Especially in the production of ABS material, it is easy to break. Experienced design engineers will first review the glue point, and through the glue point, drive the weld line to a position where no burst will occur.

After the injection molding workers of the injection molding processing factory left their posts, they spent more than 20 minutes on duty. When returning to work, they did not shoot off the waste rubber that had been in the barrel for too long and caused the rubber to deteriorate. If it is produced directly, it will also cause bursting. In this case, it will be more difficult to analyze the quality.

For more information about injection molding in Shanghai, please visit the official website of Xingye: http://www.dgxingyesj.com/.