Precautions for the use of blow molding equipment

Author: MULAN - Plastic Molding Manufacturer

​Precautions for the use of blow molding equipment 1. Before using the blow molding equipment, it is necessary to read the instruction manual of the injection molding machine used in detail, to understand the structure, transmission and action process of the machine, to understand the use of various control components and components, and to be familiar with the oil circuit diagram and electrical principles. 2. Check the fastening condition of each fastening part in detail. If there is any looseness, it should be tightened immediately. 3. Check whether the buttons, electrical switches, operating handles, handwheels, etc. are damaged or malfunctioning. Before driving, each switch handle or button should be in the disconnected position. 4. Check whether the safety door slides flexibly on the track, and whether the limit switch can be touched at the set position. 5. Check whether the oil tank of the blow molding product equipment is full of hydraulic oil. If it is not filled, the oil tank should be cleaned first, and then the hydraulic oil of the specified type should be injected into the tank from the oil filter, and the oil level should reach the upper and lower limit lines of the gauge. middle. 6. Pour lubricating oil into all oil cups and lubricating channels to make them lubricated. 7. Check whether the power supply voltage is consistent with the rated voltage of the electrical equipment, if not, adjust accordingly to make the two the same. 8. Check the cleanliness of the second working surface of the machine, remove all kinds of tools and sundries used in equipment debugging, especially the transmission part and sliding part must be clean. 9. Check whether there is any foreign matter in the hopper of the blow molding product equipment, and fill the hopper with materials.